Right-sized advice
If one tap is the only problem, a whole-house system is overkill. We tell you that up front and quote what fits.
We'll tell you when you don't need a softener · (650) 727-9630

Clean water at one tap
Compact, tankless filtration that fits in the cabinet and serves the kitchen tap. We install under-sink filters in San Mateo homes and condos near Third Avenue and all over town.
Not every house needs a whole-house system or an RO unit. San Mateo Water Filtration fits under-sink drinking water filters in San Mateo for people who mainly care about what comes out of the kitchen tap. A good one cuts chloramine taste and odor and, with the right cartridge, reduces lead from older solder.
It suits condos near downtown, rentals, and houses built before 1986 where lead is a fair question. The visit is short: we take a reading, fit the filter and faucet, and check for leaks.
Small system, but the details still matter. Here is the work.
We measure chloramine and TDS at the kitchen faucet. If lead is a concern, we also explain how to send a sample to a lab for a proper lead result.
We match the cartridge to the issue: a carbon block for taste and chloramine, or a lead-rated block for older plumbing. You get the cartridge the reading points to, not the priciest one on the shelf.
An angle-stop adapter tees off the cold supply under the sink. Your main faucet keeps working exactly as before.
The filter housing is mounted to the cabinet wall at a height that makes changes easy. We leave clearance so the cartridge comes out without a fight.
Most installs get a small drinking faucet on the sink deck. Some setups run filtered water through the main faucet instead, depending on the fixture.
The drinking faucet comes in finishes that sit well beside your main fixture. We set it where it is easy to reach without crowding the sink or the soap dispenser.
New carbon releases fine particles, so we flush it before you drink. Every fitting is checked dry before we close up.
If the fridge has a water line nearby, filtered water can feed the ice maker too. We plan that during the same visit.
You get the cartridge part number and the change interval in writing. Swaps take a couple of minutes and need no tools.
We take a reading at the kitchen tap and look at the plumbing under the sink. You hear which cartridge fits your water and why. A written quote follows on the spot. The whole thing takes a few minutes.
We tee into the cold line, mount the housing, and set the faucet. The cabinet stays usable, with the filter tucked to one side. Most installs take about an hour.
We flush the new cartridge, then run water through the faucet and check every joint. You taste the difference before we pack up. We show you how the cartridge twists out for future changes.
If one tap is the only problem, a whole-house system is overkill. We tell you that up front and quote what fits.
Older neighborhoods like Hayward Park and Shoreview have homes with original solder in the lines. We use lead-rated carbon blocks where the house calls for it.
We fit housings you can service yourself. No service contract and no special tools.
This is the most direct way to change what you drink at home. Book a short visit, see the reading, and have the filter working the same afternoon.